REPLACEMENT CABLES FOR VESPA IGNITIONS (ELECTRONIC OR CONTACT CONTROLLED)

Inexpensive and high quality solution to restore an existing ignition base plate. In almost 100% of all older ignitions the coils are still completely intact, only the cables of the leads should be replaced.

Small series '100% Handmade in Germany' made of ÖLFLEX® HEAT 180 SiF cable which is heat resistant up to +180°C.

• Suitable prefabricated for Vespa ignition base plates
• Original cable colors
• Incl. professionally assembled and insulated connector
• Inexpensive
• High quality silicone cable:
  • Fine stranded tinned copper conductor
  • Temperature resistant: -50°C to +180°C
  • Chemical resistant: Oils, alcohols, greases, etc.
  • Permanently flexible
  • Resistant to aging
• Soldering iron required for assembly

All cables have 1.0mm² cross section. The main power cables of the PX Lusso and PK ignitions (blue and black) have as in the original 1.5mm² cross-section.

Supplied are pre-assembled cable whips to solder them to an existing alternator instead of the old defective cables again.
The cables have professionally crimped cable connectors with heat shrink insulation as well as stripped and pre-tinned ends for attachment to the base plate.
The matching bougie tube for cable protection is also included, of course.